In most boundary conditions, fvOptions etc. required and optional fields
to be looked-up from the objectRegistry are selected by setting the
keyword corresponding to the standard field name in the BC etc. to the
appropriate name in the objectRegistry. Usually a default is provided
with sets the field name to the keyword name, e.g. in the
totalPressureFvPatchScalarField the velocity is selected by setting the
keyword 'U' to the appropriate name which defaults to 'U':
Property | Description | Required | Default value
U | velocity field name | no | U
phi | flux field name | no | phi
.
.
.
However, in some BCs and functionObjects and many fvOptions another
convention is used in which the field name keyword is appended by 'Name'
e.g.
Property | Description | Required | Default value
pName | pressure field name | no | p
UName | velocity field name | no | U
This difference in convention is unnecessary and confusing, hinders code
and dictionary reuse and complicates code maintenance. In this commit
the appended 'Name' is removed from the field selection keywords
standardizing OpenFOAM on the first convention above.
This changes simplifies the specification of functionObjects in
controlDict and is consistent with the 'libs' option in controlDict to
load special solver libraries.
Support for the old 'functionObjectLibs' name is supported for backward compatibility.
for consistency with the time controls in controlDict and to avoid
unnecessary confusion. All code and tutorials have been updated.
The old names 'outputControl' and 'outputInterval' are but supported for
backward compatibility but deprecated.
This condition creates a zero-dimensional model of an enclosed volume of
gas upstream of the inlet. The pressure that the boundary condition
exerts on the inlet boundary is dependent on the thermodynamic state of
the upstream volume. The upstream plenum density and temperature are
time-stepped along with the rest of the simulation, and momentum is
neglected. The plenum is supplied with a user specified mass flow and
temperature.
The result is a boundary condition which blends between a pressure inlet
condition condition and a fixed mass flow. The smaller the plenum
volume, the quicker the pressure responds to a deviation from the supply
mass flow, and the closer the model approximates a fixed mass flow. As
the plenum size increases, the model becomes more similar to a specified
pressure.
The expansion from the plenum to the inlet boundary is controlled by an
area ratio and a discharge coefficient. The area ratio can be used to
represent further acceleration between a sub-grid blockage such as fins.
The discharge coefficient represents a fractional deviation from an
ideal expansion process.
This condition is useful for simulating unsteady internal flow problems
for which both a mass flow boundary is unrealistic, and a pressure
boundary is susceptible to flow reversal. It was developed for use in
simulating confined combustion.
tutorials/compressible/rhoPimpleFoam/laminar/helmholtzResonance:
helmholtz resonance tutorial case for plenum pressure boundary
This development was contributed by Will Bainbridge
